"OPTIMAL PLACEMENT OF PHASOR MEASUREMENT UNITS FOR POWER SYSTEM OBSERV" by RAJPAL SAINI and MANJU mam

International Journal of Smart Sensor and Adhoc Network

Article Title

OPTIMAL PLACEMENT OF PHASOR MEASUREMENT UNITS FOR POWER SYSTEM OBSERVABILITY WITHOUT CONSIDERING ZERO INJECTION BUSES

Authors

RAJPAL SAINI, Department of Electrical Engineering, Deen Bandhu Chhotu Ram University, of Science And Technology (Murthal) Haryana(India)Follow
MANJU mam, Department of Power Management, National Power Training Institute(FRD.), Haryana(India)Follow

Abstract

This paper present a method to find minimum number of phasor measurement units (PMUs) for complete observability of power system network for normal operating conditions.A linear algorithm is used to determine the minimum number of PMUs needed to make the system observable without considering zero injection buses. For state estimation and fault diagnosis in power system synchronized snapshot of whole system must be necessary. The proposed method is used to benchmark the optimal PMUs placement solution for the IEEE 14-bus, IEEE 18-bus, IEEE 24-bus, IEEE 30-bus and IEEE 57-bus test systems.

Recommended Citation

SAINI, RAJPAL and mam, MANJU (2012) "OPTIMAL PLACEMENT OF PHASOR MEASUREMENT UNITS FOR POWER SYSTEM OBSERVABILITY WITHOUT CONSIDERING ZERO INJECTION BUSES," International Journal of Smart Sensor and Adhoc Network: Vol. 2: Iss. 2, Article 9.
DOI: 10.47893/IJSSAN.2012.1149
Available at: https://www.interscience.in/ijssan/vol2/iss2/9

DOI

10.47893/IJSSAN.2012.1149

Download

Included in

Digital Communications and Networking Commons, Electrical and Computer Engineering Commons

COinS