International Journal of Mechanical and Industrial Engineering
Abstract
In the present investigation the distribution of mean velocity, static pressure and total pressure are experimentally studied on an annular curved diffuser of 30° angle of turn with an area ratio of 1.283 and centerline length was chosen as three times of inlet diameter. The experimental results then were numerically validated with the help of Fluent and then a series of parametric investigations are conducted with same centre line length and inlet diameter but with different area ratios varying from 1.15 to 3.75. The measurements were taken at Reynolds number 2.25 x 105 based on inlet diameter and mass average inlet velocity. Predicted results of coefficient of mass averaged static pressure recovery (30%) and coefficient of mass averaged total pressure loss (21%) are in good agreement with the experimental results of coefficient of mass averaged static pressure recovery (26%) and coefficient of mass averaged total pressure loss (17%) respectively. Standard k-ε model in Fluent solver was chosen for validation. From the parametric investigation it is observed that static pressure recovery increases up to an area ratio of 2.86 and between the area ration 2.86 to 3.75, pressure recovery decreases steadily. The coefficient of total pressure loss almost remains constant with the change in area ratio for similar inlet conditions.
Recommended Citation
Sinha, Prasanta K.; Das, Ananta Kumar; and Majumdar, Bireswar
(2011)
"Numerical Investigation of flow through Annular diffusing duct,"
International Journal of Mechanical and Industrial Engineering: Vol. 1:
Iss.
1, Article 15.
DOI: 10.47893/IJMIE.2011.1014
Available at:
https://www.interscience.in/ijmie/vol1/iss1/15
DOI
10.47893/IJMIE.2011.1014
Included in
Manufacturing Commons, Operations Research, Systems Engineering and Industrial Engineering Commons, Risk Analysis Commons
